Kategorijos
UniBus 8 zonų išplėtėjas, Inner Range Integriti INTG-996500PCB&K

UniBus 8 zonų išplėtėjas, Inner Range Integriti INTG-996500PCB&K

Kategorija: Apsaugos sistemos
Gamintojas: Inner range
Kodas: INTG-996500PCB&KIT
Modelis: INTG-996500PCB&K
Teirautis šios prekės
Atšaukti
Laiškas sėkmingai išsiųstas.
Klaida! Laiško išsiųsti nepavyko.
Aprašymas
papildoma informacija
Atsisiųsti specifikaciją

The UniBus 8 Zone Expander connects to an Integriti Security Controller (ISC) or 8 Zone Expander Module via the UniBus Port.

It provides an additional 8 Zone Inputs that support all Integriti Zone Types including Multistate and Counter types along with extra detector power supply connections (DET+) to simplify device wiring.

The UniBus 8 Zone Expander is designed for installation within the same enclosure as its UniBus host module.

Compatible with Inception Systems
The UniBus 8 Zone Expander is compatible with Inception systems, but must be connected to an 8 Zone I/O LAN Expander as the UniBus host module.

Features

  • 8 Universal Zone Inputs
  • Support for Multistate EOL circuits
  • Support for counter type inputs
  • Programmable de-bounce times
  • DIP switch addressable first zone 1, 9, 17 or 25
  • UniBus loop-through connectors
  • 4 Way DET+ 13.75V outputs
  • 2 LED status / fault indicators
  • Surge protected inputs
  • Over-The-Wire firmware upgradable
  • Integriti “C” size footprint 94 x 94mm
  • Can be installed above other “C” size PCB’s**
  • A Snap off strip is included to allow installation above Integriti “B” size PCB’s**

**35mm standoff kit required – Part Number 999009

Host Module Compatibility

The UniBus 8 Zone Expander is compatible with the following UniBus Host Modules and connects to the host module via a UniBus patch cable.

UniBus In-Cabinet Expansion

UniBus Devices are designed for installation within the same tamper protected enclosure as the UniBus host module. A UniBus host can interface a maximum of six UniBus devices in any combination, provided they are all within the intended functionality of the host module.

UniBus is an innovative in-cabinet bus which allows the connection of Expansion devices, Communications devices and Door & Reader expansion devices on a common Plug & Play bus. UniBus is built on the highly reliable CANBus technology and replaces the need for ribbon cables and specialised connectors.

UniBus Compatibility  Chart

Unibus Device Compatibility Guide    UniBus Host Module
ISC IAC 8 Zone Expander  ILAM
UniBus
Device
            8 Zone Expander 2  0 3 0
 8 Relay Expander 4  4 4 2
 2 Door / 2 Reader Expander 0  3 0 3
 16 Floor Lift Interface 6 6 6 6
 RS-232/RS-485 UART 4 4 0 0
 Analogue Expander 6 0 6 0
 2nd Network Interface Card 1 1 0 0
Rekomenduojame įsigyti